EVS - Embarras Volunteer Stewards Homepage

Embarras

Volunteer

Stewards

Helping to preserve and restore native prairie and woodland sites

CONTROLLING GARLIC MUSTARD

Mechanical Control:

Minor infestations can be eradicated by hand pulling at or before the onset of flowering, or by cutting the flower stalk as close to the soil surface as possible just as flowering begins (cutting a couple inches above ground level is not quite as effective). Cutting prior to this time may promote resprouting.Cutting flowering plants at the ground level has resulted in 99% mortality and eliminates seed production. A scythe, monofilament weed whip, or power brush cutter may be helpful if the infestation covers a large area. When pulling, the upper half of the root must be removed in order to stop buds at the root crown from sending up new flower stalks. Pulling is very labor intensive, and can result in soil disturbance, damaging desirable species, and bringing up seeds from the seed bank. These results can be partially prevented by thoroughly tamping soil after pulling. If, however, seed bank depletion is desired, leave the soil in a disturbed state to encourage further germination, and return annually to remove the plants. In general, cutting is less destructive than pulling as a control method, but can be done only during flower stalk elongation. Pulling can be done at any time when the soil is not frozen. If flowering has progressed to the point that viable seed exists, remove the cut or pulled plants from the area. Because seeds remain viable for five years, it is essential that an area be monitored and plants removed for at least five years after the initial control effort.

For larger infestations, fall or early spring burning may be effective. First year plants are killed by fire, if the fire is hot enough to remove all leaf litter. However, the bare soil enhances survival of seedlings that germinate after the fire, and the total population may increase after the fire. Dense populations may be controlled more effectively by fall burning, when leaf litter provides adequate fuel. Spring burns should be conducted early enough to minimize possible injury to spring wildflowers. Three to five years of burning are required, and should be followed by hand-pulling or cutting of small populations produced from the seed bank. Garlic mustard plants hit by fire are generally killed. Because most woodland fires are patchy, flame torches may be useful in areas not burned in entirety.

Chemical Control:

Several infestations can be controlled by applying 1-2% active ingredient (a.i.) solution of glyphosate to the foliage of individual plants and dense patches during late fall or early spring. At these times, most native plants are dormant, but garlic mustard is green and vulnerable. Glyphosate is a nonselective herbicide that will kill non-target plants if it comes into contact with them. Managers should exercise caution during application, and not spray so heavily that herbicide drips off the target species. Herbicide use is safest for native plants if done during the dormant season, as garlic mustard will grow as long as there is no snow cover and the temperature is greater than 35 degrees F. An early spring application of tricolopyr at a 1% a.i. concentration in solution with water has been used, resulting in a 92% rosette mortality rate.

Biological Control:

Plans for research on biological control are currently underway at Cornell University, but funding is still being sought at this time.

	Embarras	Volunteer	Stewards
	Helping to preserve and restore native prairie and woodland sites

	CONTROLLING GARLIC MUSTARD Mechanical Control: Minor infestations can be eradicated by hand pulling at or before the onset of flowering, or by cutting the flower stalk as close to the soil surface as possible just as flowering begins (cutting a couple inches above ground level is not quite as effective). Cutting prior to this time may promote resprouting.Cutting flowering plants at the ground level has resulted in 99% mortality and eliminates seed production. A scythe, monofilament weed whip, or power brush cutter may be helpful if the infestation covers a large area. When pulling, the upper half of the root must be removed in order to stop buds at the root crown from sending up new flower stalks. Pulling is very labor intensive, and can result in soil disturbance, damaging desirable species, and bringing up seeds from the seed bank. These results can be partially prevented by thoroughly tamping soil after pulling. If, however, seed bank depletion is desired, leave the soil in a disturbed state to encourage further germination, and return annually to remove the plants. In general, cutting is less destructive than pulling as a control method, but can be done only during flower stalk elongation. Pulling can be done at any time when the soil is not frozen. If flowering has progressed to the point that viable seed exists, remove the cut or pulled plants from the area. Because seeds remain viable for five years, it is essential that an area be monitored and plants removed for at least five years after the initial control effort. For larger infestations, fall or early spring burning may be effective. First year plants are killed by fire, if the fire is hot enough to remove all leaf litter. However, the bare soil enhances survival of seedlings that germinate after the fire, and the total population may increase after the fire. Dense populations may be controlled more effectively by fall burning, when leaf litter provides adequate fuel. Spring burns should be conducted early enough to minimize possible injury to spring wildflowers. Three to five years of burning are required, and should be followed by hand-pulling or cutting of small populations produced from the seed bank. Garlic mustard plants hit by fire are generally killed. Because most woodland fires are patchy, flame torches may be useful in areas not burned in entirety. Chemical Control: Several infestations can be controlled by applying 1-2% active ingredient (a.i.) solution of glyphosate to the foliage of individual plants and dense patches during late fall or early spring. At these times, most native plants are dormant, but garlic mustard is green and vulnerable. Glyphosate is a nonselective herbicide that will kill non-target plants if it comes into contact with them. Managers should exercise caution during application, and not spray so heavily that herbicide drips off the target species. Herbicide use is safest for native plants if done during the dormant season, as garlic mustard will grow as long as there is no snow cover and the temperature is greater than 35 degrees F. An early spring application of tricolopyr at a 1% a.i. concentration in solution with water has been used, resulting in a 92% rosette mortality rate. Biological Control: Plans for research on biological control are currently underway at Cornell University, but funding is still being sought at this time.